Industrial Adhesive Films, Hot Melt Adhesive Films, Paper Laminating, Laminating Equipment, Fusible Webs, Pressure Sensitive Dry Film Adhesives

View our new Flexible Laminator, just introduced. Used for roll stock to panel substrates and roll stock to roll stock. The new machine has all the convenient features you would expect from HMT.

Learn More

Laminating Machine

Fabricate a wide range of laminate and substrates. Ideal for larger operations. Ready to operate in 8 to 10 minutes. 208, 240 Volt 3 Phase required. Optional 480 Volt available. Roll feed attachment for roll stack lamination. Models range manual to semiautomatic. Optional conveyor sections available.

Model	S & LS26M	S & LS50M	S & LS62M
SIZE	48x60x21.5'	77x60x21.5'	79x60x21.5'
WEIGHT	1265 LBS	2515 LBS	2740 LBS
VOLTAGE	240/480	240/480	240/480
F.L. AMPS	35/20	80/45 95/50	85/45
AIR USAGE	1CFM@80PSI (LS only)	1CFM@80PSI (LS only)	1CFM@80PSI (LS only)

Ready to Run in About 8 - 10 Minutes
No Clean Up Required
Uses Proven Hot Melt Technology
Formaldehyde Free
Adhesive is Non-Toxic and Environmentally Friendly

Finished Product can be Fabricated Immediately
No Messy White Glue or Contact Cement
Free Technical Support: 800/433-0730
No Cure Time

Laminating Machine:

4 foot model: Call for pricing
5 foot model: Call for pricing

Adhesive Cost:
Approximately 0.12¢ per square foot
Standard Roll Size: 500' length, widths up to 65".
Rolls can be cut to customer width specifications.

To learn more about our Optional Equipment, RollFeed, 480 Volt Transformer, 50"& 62" Conveyor, click here

HMT Manufacturing Laminator

Operating an HMT Laminator The following is a brief overview of operational steps of our Laminator System. Please see our operation manual for additional detail.

1	As the substrate enters the in-feed area, hot melt film is applied from the glue payout. A hot cut-off bar is then used to separate the glue from the roll.

2	The laminate sheet is selected from the rack and positioned to an indexing pin.

3	The substrate with the web is conveyed into the activation area. Infrared heatbanks flash activate the web while in motion. A finger switch is tripped by the advancing substrate initiating the laminate drive (LS series only). The laminate automatically meets with the advancing substrate with activated web. Both enter the powered pinch roller then exit to the out-feed conveyor.

4	The panel is now ready for immediate fabrication.

	Open Manual

Home About HMT Products Contact Us